Would You Like a Free Expert Consultation?

Las Vegas Handyman 

Not every project goes as well as planned. We would be happy to spend a few minutes answering your questions.

Subscribe by Email

Your email:

Browse by Tag

Pro Handyman Blog

Current Articles | RSS Feed RSS Feed

Smoke Detectors

smoke detectorsHow many times have you been awakened by a chirping smoke detector? A few times I'll bet. So you replace the battery only to find that it still chirps? Try using a vacuum with a hose attachment and hold the hose up to the smoke detector. After you suck out a few years worth of dust, plug the unit back in to see if it works. If not, you may consider replacing it.

It's recommended that smoke detector batteries be changed when you set your clock for daylight savings time and again when you set it back to standard time. It's also recommended that the entire unit be replaced if it's more than 10 years old, because the circuits wear out and eventually stop working. Also, years of dust and clumsy painting can interfere with the sensor.

Smoke detectors are inexpensive. You can buy a direct-wired unit with a battery backup for about $20. And, if you have an area where you want to add one, install a battery-operated unit, which is about $15.

To replace your direct-wired smoke detector, first turn off the power at the main panel. The top of the old smoke detector will either pop off or will twist off with a slight turning motion. On the old units, you have to remove the body of the detector to access the wires that connect it to the electricity. The body is held in place by two screws. Remove these screws and the detector will dangle from the ceiling. Test the wires to make sure the power is off, then untwist the wire connections.

Screw the new smoke detector mounting plate to the electrical box with the two screws that you removed from the old unit.

Your new smoke detector will come with a connector plug that attaches to the electricity. After you make the electrical connections, simply plug this connector into the detector.

The electrical connections are the same as replacing a light fixture, except for what is called an interconnect wire. If you have multiple smoke detectors that are interconnected, when one goes off, they all go off.

You can tell if your detector is interconnected if it has a third colored wire. Connect the white neutral wire from the ceiling to the white wire on the connector plug. Connect the black hot wire from the ceiling to the black wire on the connector plug. If your old smoke detector had a third colored wire connected to it, then connect this wire to the yellow interconnect wire on the connector plug. New smoke detectors are wired for either single or interconnected use, so just connect the new detector with the same number of wires as the one you are replacing. Use wire nuts for tight connections.

Once the wiring is done, plug the connector into the new smoke detector and twist it onto the mounting plate.

This is really a simple job. However, it's a job that is vitally important. If this one smoke detector is old, the other ones in your home probably are old, too. Do yourself a favor and spend the money to change them all.


They sure do. Don't forget to change the batteries twice per year...each time you change your clocks for daylight savings.
Posted @ Wednesday, November 18, 2009 10:20 AM by Mike Klimek
Post Comment
Website (optional)

Allowed tags: <a> link, <b> bold, <i> italics