Would You Like a Free Expert Consultation?

Las Vegas Handyman 

Not every project goes as well as planned. We would be happy to spend a few minutes answering your questions.

Subscribe by Email

Your email:

Browse by Tag

Pro Handyman Blog

Current Articles | RSS Feed RSS Feed

Door Bell Repairs

  
  
  

door bell repairsWith Halloween coming up, you'll want to make sure your door bell is working. What would be the fun if the kids rang your doorbell and ran, only to find out the darn thing didn't annoy you. Door bell repairs are a must for the season.

Most doorbell problems are caused by loose wire connections or worn-out switches. To test your system, you will need a multi-tester (under $15), which checks voltage and continuity. It will even test batteries for you.

Start by removing the screws that hold the doorbell button to the house. Pull it away from the wall and check that the two wires are securely fastened to the unit. If they aren't, tighten the screws then test the doorbell. If it still doesn't work, disconnect the wires and test the doorbell with the continuity tester. If the meter registers no continuity, replace the doorbell button.

If the button is OK, twist the wires together to test the other parts of the system (don't worry, this is a low voltage system, so it won't curl your hair). Look for the doorbell's transformer, which is a small metal box about 3 inches tall by 3 inches wide and is likely located near the ceiling in your garage, or a closet. The transformer has two screws on it with one wire attached to each screw and will have a voltage rating of less than 20.

Set the dial of the multi-tester to the 50-volt setting, then touch the probes of the multi-tester to the screw terminals on the transformer. You should get a reading within a few volts of the actual rating on the transformer. If not, replace the transformer (about $10).

If you get no reading, there may be a loose wire in the box that the transformer sits on. Shut off the power to the transformer at the main panel, remove the cover to the box then check that the connections are secure.

If the multi-tester showed the proper voltage, move to the chime unit. Remove the cover and inspect the low-voltage wire connections. If any are loose, reconnect them. Next, take the multi-tester (again set at the 50-volt setting) and touch the screw terminals inside the chime unit. If the reading shows power within a few volts of the transformer rating, then the chime is receiving the proper current from the transformer. If the test shows no power or very low power, then there is a break in the low-voltage lines, and new wiring must be installed. Re-assemble the doorbell system and push the button. If the chime doesn't sound, you need to replace it.

All Posts