Garage Door Opener Sensors

DEAR MIKE: I have a problem with my garage door opener. When I push the button, it goes up with no problem. However, when I push the button for the door to go down, it comes down about a foot, and then goes back up. If I hold the button down though, the door will close. I hope this won't be an expensive repair. -- Katie K.

DEAR KATIE: Get out your checkbook. But instead of buying a new garage door opener, you can take me to dinner.

Actually, this is a cheap fix, and you probably won't need to buy anything.

Your garage door opener is sensing there is an obstruction that will prevent the door from closing. This is due to a problem with the optical sensors. Normally, if the path between the sensors is unbroken, the door operates normally.

Let's say a child is running under the door as it is closing. The child breaks the path between the sensors, and the sensors send a signal to the opener. When this happens, the automatic reversing mechanism activates and reverses the door. This is a safety feature designed to prevent injury.

The sensors are little black boxes about the size of a deck of cards that can be found on either side of the bottom of the garage door. There usually is a light on each sensor. One will have a green light that signifies power to the units, and the other will have a red light that signifies that the sensors are `seeing' each other (i.e. that there are no obstructions).

If the red light is blinking, the sensors are not aligned. Re-align them by moving one of them until the red light stays lighted. The sensors are attached to the garage wall by metal supports, but they are easy to bend and re-position if necessary. Your problem may also be caused by the sun. If the sun shines on one of the sensors, it may hit it in such a way that the sensor's view is blocked. You can fix this by sticking a piece of cardboard in front of the sensor to block out the sun.

If the light still doesn't stay lit, there may be a problem with the wires leading to the sensors. Check that the wires are securely attached to the sensors (there are two wires to each sensor). Also check that one of the wires has not been cut; if so, strip off some of the insulation from the ends of the wires and re-attach them.

Finally, get a ladder and check the back of the garage door opener unit to make sure that the wires are still attached to the terminals.

Now, about that dinner... 
 

Need Help? Contact Us!